Hi,
Recently I want to set up a dynamic network that with the node change this position ,the network will change dynamically.But there is the question,with the node's position...
Dir Sir. I am checking the current profile of nRF24AP2 in RX mode.
After "open channel" command, I found the peak current at 10ms interval until connection pass.
How does...
Hello,
I am using Nordic's UART service to communicate with my project. I use iOS and also Master Control Panel (with a dongle) on a laptop.
I have two questions:
...
SWI*_IRQ is using by softdevice to send event to application, I want to know which priority does softdevice set for them?
Does sd_nvic_critical_region_enter() disable...
I am a started guy.
I only need a bluetooth device (BLE) to check the signal and mac address.
What is the best choice?
I need the smallest and low powered!
Thank you...
I am working on code to setup a bond manager for ancs based off of the example, but have a fixed advertising and connection interval of 25ms. How does the bond manager and...
I have an nrf52832 DK, which when on, constantly obtains and sends accelerometer data from an IMU to whatever BT device it is connected to. I also have an nrf52840 Bluetooth...
Hi,
I just want to add SPI to my BLE project to read some data from my gyro , but after spi's addition, the code doesn't work normally anymore. I print a log in the cycle...
Hello
i'm use nrf52840 and I want write external qspi flash over BLE DFU but cannot be use
how can i solve this problem?
DFU log
modified nrf_fstorage_sd...
I'm building a project for the nRF52832 using the NRF5-SDK version 14.0.0. I'm compiling using GCC 6.3.1 ( arm-none-eabi-gcc (GNU Tools for ARM Embedded Processors 6-2017...
Hello,
We are using the AWS library on a Thingy91 to enable FOTA. We have a working example where we store the bin file in S3 as instructed in the SDK documentation.
Now...
Hello, I am trying to use the Peripheral UART code with the nRF9160-DK. I followed this guide https://devzone.nordicsemi.com/nordic/nrf-connect-sdk-guides/b/getting-started...
Dear All, I was wondering if you could provide any examples or advice as to good practice techniques when using the Watchdog timer in a multi-threaded Zephyr application.
Hi all,
I'd appreciate some help on the following problem:
I'm trying to put a custom hardware into a low power sleep mode from which I want to wake up regularly. I’m...
Hello
I am doing a project need to implement firmware update from the application
and I reference bellow thread,
https://devzone.nordicsemi.com/f/nordic-q-a/68368/write...
Hi, I am trying to build the light switch server in the nRF for Mesh SDK, but I cannot generate the SES build files using cmake.
I am receiving the following error
CMake...
My central and peripheral are continuously connected at 1sec connection interval to conserve power on both devices.
When a button is pressed, I would like to exchange data...
I don't fully understand datasheet for LFXO.
17.4.3
CL_LFXO Load Capacitance = 12.5pF. Is this the recommended CL for external crystal?
RS_LXFO ESR = 100k. Is this the...
