I'm still on stack 8.0.0 so it might have been fixed since. I have noticed that if the other side de-asserts CTS the Nordic code will leave the TX asserted in a Break condition...
Hello,
I'd like to ask what is the data rate when using BLE OpenMesh network and how much it depends on network architecture.
I'm considering using it in a network consisting...
Hello Nordic Community,
I need to know how to import my PCB design from Eagle to CST Studio to simulate it and I need to know if the simulation step will be useful to enhance...
Hi.
I'm trying to get Apple notifications to nrf52. And specifically to listen both regular ANS (for android) and ANCS (for iOS) events depending what sort of phone is...
I am trying to find out the part number of the antenna (I assume it is a PCB antenna) used in the nRF51 DK ( www.nordicsemi.com/.../nRF51-DK) . I found a lot of similar questions...
Hi.
I am using the NRF52 Development board, on Keil uVision, to implement a C program that uses Dynamic Structs. The Structs re-size themselves ( by increasing their capacity...
Hello,
I have an NRF51822 (redbealab ble nano) that I would like to use to count pulses in very low power mode.
Pulses are asynchronous
The rate of pulses can...
Hi,
I'm attempting to develop chip to chip communication where an nRF9160 acts as an I2C master communicating with an nRF52840 acting as an I2C slave.
I got reasonably...
Hello.
Now, I'm trying to combine ble_app_beacon and spis.
I succeeded in building and it generates hex file.
The problem is that the device stops sending BLE data ...
Hi, I am trying to send and receive strings using examples\peripheral\libuarte. I am trying to send a string like this but not receiving it on another board. Also how can...
I entered the bootloader mode of nRF52833DK, but I cannot exit it. When I reconnect the device LED5 is not on and the J-link driver doesn't appear as the removable driver...
I want to increase the throughput as much as possible from the central to the peripheral, but when the number of consecutive calling bt_gatt_write_without_response_cb() or...
Hi,
We are evaluating the nRF52840 dongle. We need to dictate, have a conditional connect feature based on the BLE version. We should specify that use the BLE version...
Hello everyone,
I just wanted to post an important detail when using Nordic's DFU.
After the successful run of the Nordic's buttonless DFU example (by following this...
Hello All,
I am developing a product based on thread protocol.
I am using nRF52840 development kit and nRF5_SDK_for_Thread_and_Zigbee_v4.1.0_32ce5f8 SDK.
I am new to...
After upgrading segger to 5.42 we are now getting the following error when compiling the Bluetooth DFU bootloader part of our existing projects
section .uicr_bootloader_start_address...
Hello,
I am developing an application using
1. SEGGER Embedded Studio.
2. SDK 17.0.2.
3. Cortex-M nrf 52840.
Recently I changed the OS from FreeRTOS to embOS and...
Hello Devzone,
We update our peripheral device(nrf52) with our gateway(nrf52840, central) using the DFU protocol. We have this working and the DFU update is successful when...
Hello,
I am using CUSTOM service in nrf52 for BLE Communication.In the tutorial, there isn't any BLE READ event but I figured that BLE_GATTS_EVT_RW_AUTHORIZE_REQUEST event...
Is there any example for using the Watchdog with the BLE Mesh?
Experiencing some asserts, and would like to restart the device if it happens.
There is an example for the...
