Hi all,
I am using ble open mesh with pca10028 boards ble mesh is working fine.
I am developing a application that has to blink led in mesh( without any delay between...
I'm still on stack 8.0.0 so it might have been fixed since. I have noticed that if the other side de-asserts CTS the Nordic code will leave the TX asserted in a Break condition...
Hello,
I'd like to ask what is the data rate when using BLE OpenMesh network and how much it depends on network architecture.
I'm considering using it in a network consisting...
Hello Nordic Community,
I need to know how to import my PCB design from Eagle to CST Studio to simulate it and I need to know if the simulation step will be useful to enhance...
Hi.
I'm trying to get Apple notifications to nrf52. And specifically to listen both regular ANS (for android) and ANCS (for iOS) events depending what sort of phone is...
I am trying to find out the part number of the antenna (I assume it is a PCB antenna) used in the nRF51 DK ( www.nordicsemi.com/.../nRF51-DK) . I found a lot of similar questions...
Hi.
I am using the NRF52 Development board, on Keil uVision, to implement a C program that uses Dynamic Structs. The Structs re-size themselves ( by increasing their capacity...
Hello, Nordic developers. The ZED , ZR and ZC connections were identified by the example of Zigbee Light Control example .
Based on this example, we are going to develop...
I am using the gazell protocol of nrf52840, How can I specify the correspondence address of this different handles when I USE A HOST to communicate with eight handle devices...
Hi,
I have looked at the different post regarding the nRF9160 and SPI, but I can not get it to work on our custom board.
Attached the board definition files.
Here...
I have the Thingy91 plugged into a macbook pro(osx catalina) with usb.
I have updated the firmware on thingy 91 with the precompiled application and modem firmware ( 2020...
We are able to form a openthread mesh using CLI-ftd examples.At present we have server communicating to Clint in UDP portal .Is there is any UART command which is meant for...
Hello.
I am using SDK v17.0.1, nrf52833.
I can enter DFU Mode with pressing Button 4 and reset Button.
However, I want to enter DFU mode without any Button.
I've...
Hi everyone,
I'm starting from USBD example and I want to implement a composite device.
If I want to implement a composite device I have to add one interface and then...
I'm working with several Samsung SmartThings and I am wondering if a call to will address this the issue of devices leaving the network insecuely https://www.samsung.com/sg...
Hello everyone, The last few days I was advised to buy the nrf52840 DK. Up to now I have worked with the dongle. I read online the need to download the j-link software. Where...
Currently, I'm switching my platform form nRF52 to nRF53.
For the work I'm doing, I need to use DPPI to enable GPIO events to trigger SPI transmissions, without interrupting...
Hello,
Looking for some background info for SOFTDEVICE ASSERTION 0x0002715e. sdk 15.3, SD s132_nrf52_6.1.1
Maybe related, there is no Assert if fds_record_write() is done...
Hello
I am developing devices including nrf52832 and 3.3v buzzer. However, the buzzer in this device is very hot and the battery is running out quickly.
Now I know that...
Hi. I always appreciate to your kindness and fast reply.
I want to extend BLE range from 200m ~ 500m using FEM.
For the first time, I choose SKY66111 but it is not working...
