Dear Nordic Experts, This one's a tough nut to crack:
The firmware is based on nRF5 SDK for Mesh 5.0.0 with nRF5 SDK 17.0.2 and Softdevice s132 7.3.0. It runs on a nRF52832...
SoC: nRF5340 SDK: nRF Connect SDK 1.9.1
CMAC calculation works fine with SDK 1.7 and SDK 1.8. But it failed with SDK 1.9.1.
psa_mac_sign_setup returns error = PSA_ERROR_NOT_PERMITTED...
Hi, I'm pretty new to microcontroller programming so please correct my wrongs.
I'm using the Libuarte driver library to have the pca10040 talk to my server via serial connection...
Hello,
Fllow the guide of Configuring and performing DFU over Mesh,I can update firmwre successful use DFU:
Source: Example/Dfu
Target: Blinky(about 180 segment)
But...
Hi, I am working on custom board with nrf9160. I want to use LTE LINK MONITOR but my uart don't work. I create simple helloworld application from samples. I change uart0 rx...
Hi there,
We are seeing a massive difference in UART current between the same revision 2.0.0 nrf5340 devkits. Below, with the UART enabled with HWFC and only the receiver...
My project is using nRF52840. Early software development used an nRF52840-DK to develop most of the software. Software is based on Zephyr using nRF Connect version 1.6.1....
Subject pretty much says it all. I'm looking for a Zephyr project example that uses PHY CODED. I'm using the nRF52840 with NCS 2.0.2 in the vscode environment. I have things...
Hi
We have a freeRTOS project using nRF52840, I found that if I put SPI transfer API before running task is OK, but it has a problem if I put in the task,
Does anyone...
I'm running through the tutorial page to help me get stated.
The section I'm having trouble with is Updating through USB
the Problem is on step 15
When I click on...
Hi everyone,
I'd like to check devices is still alive in the BLE mesh network but I don't know how to check it. Can I use available model in SIG or custom new model to check...
nRF Connect SDK v2.0.0
For example, the current version is v5.0, you cannot upgrade to v5.0 or downgrade to v4.9. You can only upgrade versions above v5.0.
Hello,
I'm working on an application and implementing the DFU feature. I first made DFU work on a s132 application and now I'm changing to s332 so I can put the ANT+ part...
I use nrf52840 dongle programmed with zigbee cli agent example.
Using the bdb start command, the coordinator enable the permit join and connects to all free devices in the...
Will it be possible?
Can I operate the UARTS in parallel - both recieving data at 38Kbs?
The data from each UART will be stored in a buffer and once it reaches 10 bytes...
