But now I have a new problem that is whenever I set " PWR_UP " bit in CONFIG register then it drop the 3.3 volt vcc to 1.2 volt. I don't know why its happening. Anyway, is...
This previous question about multiple advertisements seems to be related to softdevice 7. I was unable to get a similar example working in SD/SDK8
My end-goal is to add...
We are considering using Gazell for an outdoor application, i.e. lots of noise and disturbances, constantly changing environment, where the amount data being transferred is...
Hi everyone,
I have found your git "Ble Optiboot"( github.com/.../ble-optiboot) , and I have understood, it is usefull to load a binary into MCU flash, I was looking for...
I'll go ahead and describe what I need to do and see if anyone might have some place to start for me since I'm having a lot of trouble figuring out what I need.
I'm looking...
Hello ,
I'm designing an embedded system with one of your RF chips (NRF24L01+) and as far as I searched for the datasheet , It seems like NRF24L01+ doesn't have a hardware...
Hi,
Currently, I am using the nrf52840 (ISP1807) for my device, I am presently flashing it with my pc with nrf connect program and taking the necessary pin out from the...
Hello,
Based on the nrf_cloud_mqtt_multi_service sample I am trying to create a MQTT connection to the nRF cloud.
I am able to successful create a connection, but after...
Hi,
I want to use Bluetooth LE in a project for nRF9160DK. My understanding is that the main program should run on the SiP nRF9160 and it will be the nRF5280 that will perform...
Where can I find a specification with time for advertising device waits after sent adv packet for connection from central to it?
What time I have for handle some logic on...
Hi,
I'm using nRF52840 dongle and nRF connect SDK 1.6.0 (Zephyr) to create a BLE HID + USB CDC device. Is it possible to jump to bootloader from application code (or ideally...
We followed the below with Apple phone iOS 16.1.2 for provisioning.
developer.nordicsemi.com/.../sample_description.html
We completed provisioning the device.
But we...
Hello,
I have a custom prototype board using the nRF9160 that will gather GPS position information as a feature. The (previous)first PCB (of the exact same board) that I...
Hi,
ncs v2.2.0 sample, central_nfc_pairing, use NFC reader to pair.
If I want to use another mcu as host with NFC reader, and communicate nRF5340 through UART.
Which...
Is there a guide to adding a peripheral device using the PinCtrl module?
I am looking for something like
But using the newer module included in ncs v2.x.x.
Hi,
I am having trouble getting the build to complete for the Audio DK demo ( https://developer.nordicsemi.com/nRF_Connect_SDK/doc/latest/nrf/applications/nrf5340_audio...
Hey!
Is it possible to flash/program the NRF5340 over USB data lines? I've integrated a 2 wire SWD interface, but it would be incredible if I could remove it and just use...
Hello All.
I am new to BLE mesh development as well as the Zephyr RTOS. We are testing BLE mesh sensor network and we require AES encryption as the hardware supports it...
Hi,
I'm implementing usb communication using nRF52840-CIAA.
I used usbd(peripheral) example of sdk 17.1.0.
This is my board circuit.
- DVDD_MDBT42P : 3.3V from LDO...
