We are considering using Gazell for an outdoor application, i.e. lots of noise and disturbances, constantly changing environment, where the amount data being transferred is...
Hi everyone,
I have found your git "Ble Optiboot"( github.com/.../ble-optiboot) , and I have understood, it is usefull to load a binary into MCU flash, I was looking for...
I'll go ahead and describe what I need to do and see if anyone might have some place to start for me since I'm having a lot of trouble figuring out what I need.
I'm looking...
Hello ,
I'm designing an embedded system with one of your RF chips (NRF24L01+) and as far as I searched for the datasheet , It seems like NRF24L01+ doesn't have a hardware...
Hi,
This post is very old.
devzone.nordicsemi.com/.../
I have a nrf51822 chip and I'm using it as BLE and it exposes some service and characteristics and it is working...
Hello!
I set up a project using NRF24L01 and a patch antenna ceramic, the type used in GPS.
In fact, I tested several types of antennas, F, F inverted, GPS, Loop. But...
Hello,
I'm trying to create a PC application to read out some Ti Sensor Tag modules. I'm using a nRF51822 USB dongle and the Master Emulator api.
The nRF dongle sees...
Hello
I am trying to upgrade a nRF52840 dongle via USB but it fails every time. I tried with my Ubuntu laptop and with a Raspberry pi 4 with same failure.
nrfutil dfu...
BLE_HCI_REMOTE_USER_TERMINATED_CONNECTION Hi,
I've implemented a Central role application on the nRF52832 that scans for a particular Peripheral (with a specific UUID into...
sI am trying to turn on or off switch. When I measue voltage on feet of the switch it is always 3.3V. There is no change. I am setting pin on or off and I get state of pin...
MPU6050 cannot calculating the value of 3 axis and the value return is 0. What is problem? How can I fix it ? Thanks for helping me. AD0 open.Adress is 0x68
Here is my...
Hi，everyone：
I tried HSS mode, but it can't meet my needs.
When I use RTT mode, the configuration is as follows
test code:
RTT viewer:
but, J-scope has been...
Hello All,
I have ported the UART example ( <InstallFolder>\examples\peripheral\uart ) on top of blinky in nicla sense hardware. The TX is working only when rx pin is set...
Hi,
I'm trying to build a proof of concept for a BLE gateway that captures data from BLE sensors and sends it to the cloud via LTE-M connection. I'm hoping that the gateway...
Hi, we are developing a project based on the LWM2M client, everything is working fine but now we need three non volatile variables. We did some testing with the nvs example...
Hello,
I have recently been able to connect to multiple sensors using the nrf connect 2.0.0 SDK and nrf 52840 dongle as a central device. I was wondering how I could configure...
Hi,
I would like to create a multiprotocol BLE/Zigbee coordinator project on NRF5340 with VScode.
I can't find an exemple nor guide on this except from this one:
https...
What does this error mean?
here is my error massage.
<info> app_timer: RTC: initialized. <info> app: Debug logging for UART over RTT started. <info> app: Connected <error...
Hi, Does anyone know the quiescent/average power consumption of the IBasis sim card. I have a design based on the Thingy:91 and I am wondering if it is worth moving from the...
Hi, I'm developing an project that using 2 UARTE. My code flow is 1. when timer handler has expried ( set timer_expired_flag = true) (using app_timer) 2. Enable uarte1 to...
