Hi,
I'm running Mac OS X 10.10.2 with the nRF51-DK PCA10028 card that I received today. I started off following the instructions in this article , and was able to get JLinkExe...
Hello,
I would like to do an communication between Arduino and Android platform.
In my case, Android will be master.
But I want also test between 2 Arduino with an Bluetooth...
Hello,
I would like to develop a custom key sharing algorithm for nRF8001 chips. As far as I have understood the only way to use full 128-bit temporary key (TK) is OOB...
i am useing nRF51822 pairing with nRF24lu1 over GZLL protocol now,
is there someone have the experience on how to config the parameter of GZP_TX_RX_TRANS_DELAY in function...
I have a peripheral running the S110 stack, which presents a characteristic to which I want the central (running S120) to be able to do a long write. What I've been trying...
Hi all,
I have been trying to combine the UART and hID Keyboard examples into a single application.
I want to use the HID part to send specific keystrokes using buttons...
Hi,
I'm using the nRF52840 using SDK 17.0.2. I've implemented the CLI for flashlog as well as several other custom commands. It works well when entering commands on the...
Hello, I am studying the subject example project to understand how to create my own characteristics and adapt the project for our application.
What is the purpose of the...
how to compile openthread library files for nrf52833,
i followed the procedure as below
start with a fresh copy of the SDK, and make sure you place it as close to the...
Hi Everybody,
We found little or no literature about readback_protection on the nRF5340 SOC. Our issue is that for development and debugging it is not practical to use nrfjprog...
I have created an application using SoftDevice S112 using board pca10056e and installed it on the nRF52840 DK. I want this application to run on the nRF52805 so I want to...
Dear Nordic support,
We are trying to know the power consumption of nRF52840 SoC, by prediction and measurements.
The Online Power Profiler for Bluetooth LE tool estimates...
Hi,
I am developing a product based on a nRF52833-QDAA chip, we use the two uarts to transmit data to another MCU and AT commands to a LTE-M modem.
We use NCS 1.7.0 as...
The nRF connect program for desktop
https://www.nordicsemi.com/Products/Development-tools/nRF-Connect-for-desktop
Will it be updated to fully support Bluetooth 5? Extended...
Hi,
I got a problem with sending data via gazele protocols, i'm using example library gzll_ack_payload_ host and device, can somebody explain me how this code works?
i...
Hi.
I'm working on macOS Monterey 12.0 beta and trying to start nRF Connect for desktop (version 3.7.0). When i'm trying to start this application it's starting as blank...
Hi.
This question is to confirm again about below.
Is it possible that implement multiple advertising sets, some of them would be 1M and some would be CODED PHY. And...
