Using the nRF Beacons app, but cannot see the battery condition of each beacon. Is this already implemented - if so how to turn on? If not how is it implemented?
Using the nRF Beacons app, but cannot see the battery condition of each beacon. Is this already implemented - if so how to turn on? If not how is it implemented?
Hi All
I am doing a BLE based project using nRF51822.Where i need to handle the message [with UUID] by using ble_gatts_char_handles_t.
so, can any one please share information...
I have a central application and peripheral application that are based on the multilink-central/multilink-peripheral examples.
I've modified them to run on the PCA10001...
Hi All,
I'm using nRF24L01P for TX device and want to receive packet from nRF51822 RX device.
nRF24L01P TX device Register settings are as follows;
Reg.EN_AA=0x00...
I am trying to develop for some nRF51822 mbed boards, and I would like to use the S130 SD to enable both central and peripheral behaviour. The machine I'm using for development...
I'm using the nRF51822 eval kit
I have installed MCP but after starting I get pop-up: Master Control Panel has stopped working
In nRFgo Studio / Device manager pane...
Hi all After successful installation of an update with the hep of dfu_target module, I am expecting the bootloader to swap the image and boot the new image with swap_type...
Hello! I have a nrf52840 DK. I am trying to build a custom keyboard on that SoC. I was able to compile and install nRF Connect SDK example on my DK. Everything works! ZMK...
Hello,
In continuation to the ticket: https://devzone.nordicsemi.com/f/nordic-q-a/70795/replacing-s140-with-s340-softdevice
I'm trying to switch between S140 and S340...
Hi,
I think I found a BUG about SPIM SDK15.3. The following is what I set the configurations for the SPIM0:
Then I use this function to active one transfer which just...
Hi,
I'm using nrf connect SDK 1.7 and following below guidelines to add I2C.
https://devzone.nordicsemi.com/nordic/nrf-connect-sdk-guides/b/peripherals/posts/twi-ic2-implementation...
Hi,
we have few queries regarding lighting mesh models support in ncs1.6.1
we were using NCS1.6.1 for mesh development
we were facing some compilation issues with LC...
I am using nRF52840 Dongle as Sniffer using Dongle. But when it captures the advertising packets,i am not able to see the preamble in the decoded packets. Please help!
Hello Everyone
I am really new to everything here, i just got nRF 9160dk board.
Can anyone please tell me the step-by-step method on how to make a very simple program...
Hello DevZone,
I am planning on making a system that uses peer manager ranking to determine which oldest bond I need to delete to make room for a new one.
I am using...
Hi Team,
we're developing firmware to send long range beacon by using LECODED phy channel. We notice that there is increase in energy consumption during advertising and...
Goal: Using NRF9160DK board, communicate nrf9160 and nrf52840 over UART
I tried to use UARTE on both sides. Below is project configuration and overlay file for both boards...
Hi,
I was using the AWS-IOT example and all was working until it wasnt. In troubleshooting this, I loaded the modem shell example, to see if it was a network/connection...
Hi everyone,
I implemented nrf5_SDK_17.0.2 ble_app_uart example, so I connected an external device to my nRF52840 DK and I received the data by my android phone.
Now I...
