Hello!
I think there is a problem in NCS v3.3.0. nRF54L target, sysbuild build with MCUboot and TF-M, partition layout coming from devicetree (SB_CONFIG_PARTITION_MANAGER...
Hi, I'm developing a keyboard-pcb with NRF52840. I'm doing this as a hobby and are not that experienced with integrated circuits. Anyway, I designed and produced a pcb, but...
Hello,
in cases where the LTE signal strength is extremely low, we observed that the LwM2M /4/0/2 RSRP rolls over from -128 to 127. We found that the nRF Connect SDK uses...
As part of the Bluetooth LE course we need to setup and install the nRF BLE sniffer for wireshark. I have followed the explained steps in the course to set up wireshark to...
The at command documentation says that ENVEVAL is only available in system mode 2 (CFUN=2). Is there a reason why the command can't be run in any other mode? For example if...
Hi
The TWI driver has a twi_clear_bus() function but the TWIM does not.
I'm getting an I2C error, and need to do I2C soft reset. I'm doing this manually at moment but...
I recently completed a field-upgrade path from an nRF5 SDK 17.1 application (with the legacy Secure DFU bootloader) to a fresh NCS-based firmware stack, while preserving user...
Does anyone uses Sloeber to program nRF52? I have an issue, when I add a header nrf_temp.h to the project and using following functions:
The problem appears when I add...
Dear Nordic team,
We are developing a BLE application for IOS and Android. On Android, we utilized your Nordic Scanner Lib to scan Bluetooth devices and it is fine and...
Hi. I am trying to stop advertising after a delay in the UART example using;
sd_ble_gap_adv_stop(???)
What do I put in the brackets? It is asking for a uint8_t called...
Hi,
How to stop freeRTOS xtask using timer and recreate again when needed? I'm currently want to control the blink interval, for example I want to have the led blink for...
I used sdk15.2.
The peripheral sends the public key to the central.I received an exception to public key processing.
code:
case BLE_BITBUTTON_C_EVT_BITBOTTON_M_NOTIFICATION...
Hello Everyone,
Struggling with evaluation of Secure DFU over UART lines. I used the sample project "Secure DFU Bootloader over Serial Link (UART/USB) ", during the previous...
Hello -
Any advice on finding a connector from a standard NFC Antenna to the Molex 051281-0594 connector on the Nordic Thingy:52 Board?
I am trying to find a larger NFC...
Hi all,
As we see the release note of the Mesh SDK V3.0, one of the descriptions as below:
Example changes
Lowered the default Node Identity advertisement interval....
Dear support team,
i hope you are doing good.
i am using nrf51822 customized board, SDK 12.3.0 version keil 5.26 is development on windows environment.
softdevice...
We have an app that uses UART. It works flawlessly when only SD and app are present on a chip.
But if bootloader is used, UART does not work.
Why is it so? How to fix...
Hi,
I am using NRF52832 for my project. I need a support to handling oscillator
my project needs to reads the sensor raw data and through it in BLE_UART. and do calculation...
I am using nRF Connect for desktop v2.6.0 with an nRF51 dongle. On my device, my Bluetooth Device Name String is 23 characters long. The string is too long to completely show...
Hi,
I'm developing an android application with multiple BLE.
And I can connect more than one device and successfully disconnect what I want.
But I have one problem, when...
