Hi all,
I am using ble open mesh with pca10028 boards ble mesh is working fine.
I am developing a application that has to blink led in mesh( without any delay between...
I'm still on stack 8.0.0 so it might have been fixed since. I have noticed that if the other side de-asserts CTS the Nordic code will leave the TX asserted in a Break condition...
Hello,
I'd like to ask what is the data rate when using BLE OpenMesh network and how much it depends on network architecture.
I'm considering using it in a network consisting...
Hello Nordic Community,
I need to know how to import my PCB design from Eagle to CST Studio to simulate it and I need to know if the simulation step will be useful to enhance...
Hi.
I'm trying to get Apple notifications to nrf52. And specifically to listen both regular ANS (for android) and ANCS (for iOS) events depending what sort of phone is...
I am trying to find out the part number of the antenna (I assume it is a PCB antenna) used in the nRF51 DK ( www.nordicsemi.com/.../nRF51-DK) . I found a lot of similar questions...
Hi.
I am using the NRF52 Development board, on Keil uVision, to implement a C program that uses Dynamic Structs. The Structs re-size themselves ( by increasing their capacity...
I found that CoAP requests unexpectedly block GPS positioning. So, the solution is to add a synchronization semaphore between them. I stopped the CoAP request while waiting...
Hi Team,
I am planning to implement a secure boot mechanism on the nRF5340 for one of our products and would like to ensure the design is robust, scalable, and production...
Hi
I am using nRF54L15DK, with SDK v3.2.2.
I want to implement an event log, persistent in Flash.
Initially I thought of using FCB, but I am running in to issues with...
Symptoms
A GPIOTE event channel is configured to detect a rising edge on a GPIO input. Via PPI, the event drives a GPIO output low within a few hundred nanoseconds. The...
Hello all, I am following up on a related issue regarding mcuboots partitioning and image validation. ( link to previous MCUBoot QA forum ). I have devices out in the field...
NPM1100 outputs VOUTB (2.1V) to power the NRF52832. Programming is performed via J-Link with an external 3.3V power supply. However, this causes a short circuit between VSYS...
Hi,
I’m working with the Raytac BC833M module (nRF52833) and programming it via nrfjprog in a batch script.
I need to:
Program my application firmware
Configure...
I have an interrupt handler that sets a flag some of the time, and then runs other code in main whenever that flag is set. The code looks roughly like this:
I have debugged...
I'm trying to commit a VS Code project to source control and don't want to include the entire build directory (with all of the build-generated files). But it seems that all...
Hello Team,
I have downloaded hello-nrfcloud/firmware source from Releases · hello-nrfcloud/firmware link.
I am not able to build the source provided using VS Code.
...
I've designed a custom PCB for nrf52832.
The chip is getting programmed for GPIO and working fine. But when I'm programming it for I2C it is not working. The chip is getting...
i have a "bare-metal" (register-level access) BLE advertising program which does not consistently consume the same amount of power when transmitting.... here's what the power...
Hi,
I had some issue with my nRF52 DK PCA10040 v3.0.3, The programmer was totally unreachable also with the simplest terminal command so I tried to reprogram it trough hidden...
I am trying to implement GPS code in the nrf9160 but I cant find the function nrf_modem_gnss_init(); to initialize GNSS inside the modem in , is it being initialised within...
