Dear Nordic Experts, This one's a tough nut to crack:
The firmware is based on nRF5 SDK for Mesh 5.0.0 with nRF5 SDK 17.0.2 and Softdevice s132 7.3.0. It runs on a nRF52832...
SoC: nRF5340 SDK: nRF Connect SDK 1.9.1
CMAC calculation works fine with SDK 1.7 and SDK 1.8. But it failed with SDK 1.9.1.
psa_mac_sign_setup returns error = PSA_ERROR_NOT_PERMITTED...
Hi, I'm pretty new to microcontroller programming so please correct my wrongs.
I'm using the Libuarte driver library to have the pca10040 talk to my server via serial connection...
Hello,
Fllow the guide of Configuring and performing DFU over Mesh,I can update firmwre successful use DFU:
Source: Example/Dfu
Target: Blinky(about 180 segment)
But...
Hi, I am working on custom board with nrf9160. I want to use LTE LINK MONITOR but my uart don't work. I create simple helloworld application from samples. I change uart0 rx...
I found many relative topics about improving throughput for ble link on this website. And this one How do I calculate throughput for a BLE link? told me how can I calculate...
Hi!
Whether there are any special requirements for SPI chip NRF24LE1 labeled NRF B 24LE1D ?
My programmer (mPro) do not work with this chip SPI.
rergards,
Andrii...
Hi all,
I am new to the EE/hardware world. Coming from the CS side, I am trying to grasp little bit of knowledge every day.
I looked at the reference designs and am...
Hello,
i have just a short, easy question, but i couldn't find the answer in the datasheets.
Normally the ports on the 6310 board can deliver ~3.3V. Is it possible to...
Hi,
I cannot find "Master Control Panel" for MacOS, can I test with iOS or MacOS itself? None of them seems to able to discover my PCA10001 running S110+nAN36 LED.
Thank...
Dears :
we will use WLCSP package. And, we want to know more information about it as below:
1.Marking side is strong enough right?
2. We only need to take care of side...
Hi,
I am new to ble stuff. I want to write a hex value (0403FEA27469) to a characteristic on the heartrate device.
Following is what I have done so far.
Can anyone...
I am trying to send some data between devices using the micro esb library while still running the BLE peripheral stack. My code is based on the sample nr51-micro-esb. Are...
I was using TIMER1 PPI and GPIOTE to setup a PWM signal on a GPIO line. This PWM will start and stop after 1 seconds. I used led.c to based my code. I was starting the Timer1...
Hi,
I'm having a hard time figuring out how to load and store application context from the device manager without being connected to a peripheral.
According to the device_manager...
hi all:
how to use sd_ble_gattc_relationships_discover to discover att handle?
as my question Use Nordic BTLE Soc with other Vendor BTLE Compatibility
i found this...
