Hi Nordic Team,
The atomic fifo implementation is based on armv7-M, right now I want to port it into cortex-A processor, I made some changes to get it compiled without...
Hi,
Kit:nrf5340
Can you please tell me if there is any example in nrf connect SDK v1.5.0 related to data transfer concepts.
Is ble controller will be enabled during...
I'm was testing the gsp sample in samples/nrf9160/gps. It runs fine on my nRF9160DK and reports NMEA messages. However, when i ran it on my custom board, it failed in setup_modem...
Hi,
I'm attempting to obtain sensor values for a project to be completed less than a week from now and I have not yet started programming so any help would be greatly appreciated...
Hi
I am using nrf52832,SDK version: SDK : RF5_SDK_17.0.2 .
USE CASE:We have two central and one peripheral.We need to control two central with one peripheral(REMOTE...
Hello,
I am facing an issue with SPI when the SoftDevice S132 is enabled and i cannot figure out what the problem is.
The following test works perfectly when SoftDevice...
My application flashes an LED periodically, and I would like to synchronize the LED flashing with radio idle time in order to minimize max current draw. It seems that using...
Hi everyone,
I use the function nrf_queue_write for queueing data. Also I use the NRF_QUEUE_MODE_OVERFLOW mode to overwrite old data in case the queue is full.
My problem...
I am working with a sensor IC (IQS572) that communicates via I2C with my main microcontroller. Im using the nRF52382 chip. This sensor IC has a 7bit I2C slave address, but...
I am building a USB CDC device. I noticed in the sample project there is a call to app_timer_init.
Does App USB actually use App Timer internall?
Thanks
I believe that it may be advantageous (in some cases like an application short on FLASH with significant free RAM ) for a version of the soft device to
have a significant...
Hi ! I started learning nRF Connect SDK and try to analise sample "Bluetooth LLPM".
On nRF52840 board (PCA10056) all work fine but when I try to test this sample on PCA10059...
When the nRF5340 is in RXIDLE state and it receives a valid preamble but the Access Address does not match any of the configured logical addresses, does the RADIO automatically...
Env: SEGGER Embedded Studio success build many mesh sdk project; Nordic command line also install and run.
1. Install windows amd64 ncs sdk 1.7.1
2. Click "Open IDE" button...
hi support team,
i have two questions:
1.
Attached is the SLM communication log with new 9160 DK board
I am using NB card, and 9160 takes about 20 seconds to attach...
Dear All,
is it possible to configure the nRF9160 modem not to auto connect to a LTE network when at+cfun=1 is sent? I know that with at+cops a specific operator can be...
Hi all,
I'm implementing a lwm2m client on a NRF9160 and have a problem with read/write resource instances. I use Leshan demo server to test the object and a came across...
Hello,
I am working on a project where I need to update 100 clients at a relatively high update rate. The clients are spread out in a room of about 15 x 30 meters. I will...
Hello.
In our project we must have FOTA functionality, and we want to encrypt these updates
I'm trying to create an encrypted firmware image update for MCUBOOT with "blinky...
Hi I'm trying to create a release build but I have the problem that I can't seem to get zephyr to build without debug data included. I would really appriciate some help with...
