after flash DFU program into pca10001 board, com3 is not accessible,
www.dropbox.com/.../Screenshot 2014-04-26 15.41.47.png
even after I erase all, and re upload soft...
Using S120 V 8.0.0.3 alpha, processing a BLE_GATTC_EVT_READ_RSP,
received 0x16 bytes of data but there is more to read. Next call to
sd_ble_gattc_read using the same connection...
Hello：
Why Bluetooth Go to system-off mode, sd_power_ramon_set can not be stored. In D: \ RAM save nrf51_sdk_v5_2_0_39364 \ nrf51822 \ Board \ nrf6310 \ s110 \ ble_app_rscs...
Hi,
Recently I want to set up a dynamic network that with the node change this position ,the network will change dynamically.But there is the question,with the node's position...
Dir Sir. I am checking the current profile of nRF24AP2 in RX mode.
After "open channel" command, I found the peak current at 10ms interval until connection pass.
How does...
Hello,
I am using Nordic's UART service to communicate with my project. I use iOS and also Master Control Panel (with a dongle) on a laptop.
I have two questions:
...
SWI*_IRQ is using by softdevice to send event to application, I want to know which priority does softdevice set for them?
Does sd_nvic_critical_region_enter() disable...
Hi,
I am unable to use the new nrfutil to do even a device reset of my devkit. I have installed the recommended segger version and the apple-silicon version of nrfutil...
Hello,
I'm using nRF SDK 2.7.0 and trying to implement PSK type bonding.
From quick ChatGPT search it looks like in past SDK versions there was a way to inject pre shared...
Issue: I am trying to flash the zephyr sample code into custom board with nrf52840 chip. I am frequently getting the recovery failed error or the JLinkARM DLL error. I have...
Hello, I am currently working on a project where i need to read the consumption with a PPK2 through an ESP32(use it in place of a computer). Is there by chance a pin on the...
Hello everyone,
I have been assigned the task of finding a wireless modem with integrated LTE Cat-1 bis support. I've come across the nRF9161/60/51/31 family, which indicates...
hello Nordic
i am working with ncs v2.5.0 with nrf52840 and nrf52832
i use cbor for some command i build over smp (user groups >64)..
i have this code part
i see...
Hi，
When add Homekit using the Matter Template(SDK V2.8.0) routine on the NRF52840DK development board, Homekit displays a final result of failed pairing with accessories...
We developed firmware based on the sample provided at the following link to pass Japan's technical standards compliance test https ://docs .nordicsemi .com /bundle /sdk_nrf5_v17...
I tried to use nRF54L15DK for program development, but so far I have run into some issues:
I wanted to use the coprocessor from nRF54L15DK to do some data processing, and...
Previously, nRF Connect SDK was working without issue. However, now when I try to create a new build configuration, it hangs at the following step:
It's unclear why this...
The instructions are: On the command line, open the directory ncs . The following steps have one do a west init directly in the directory ncs. But they should say to create...
i used sdk version 15.2 everything work fine but in ios 15 its not show services when android work fine and ios 14.8.1 also work fine and show services please help
