Hello：
Why Bluetooth Go to system-off mode, sd_power_ramon_set can not be stored. In D: \ RAM save nrf51_sdk_v5_2_0_39364 \ nrf51822 \ Board \ nrf6310 \ s110 \ ble_app_rscs...
Hi,
Recently I want to set up a dynamic network that with the node change this position ,the network will change dynamically.But there is the question,with the node's position...
Dir Sir. I am checking the current profile of nRF24AP2 in RX mode.
After "open channel" command, I found the peak current at 10ms interval until connection pass.
How does...
Hello,
I am using Nordic's UART service to communicate with my project. I use iOS and also Master Control Panel (with a dongle) on a laptop.
I have two questions:
...
SWI*_IRQ is using by softdevice to send event to application, I want to know which priority does softdevice set for them?
Does sd_nvic_critical_region_enter() disable...
I am a started guy.
I only need a bluetooth device (BLE) to check the signal and mac address.
What is the best choice?
I need the smallest and low powered!
Thank you...
Hello, I am working on the NRF9160DK and I have an issue with the asset tracker sample. Firstly, I followed the guidelines explained in the video "Unbox and get your Nordic...
hi support team,
i have ESB project for customer, and now i have one fundamental question about RTC cc compare event, i am struggled in this problem.
static __INLINE...
Hi,
I'm working on direction finding with nrf52833dk (my own board latter on) and Nordic antenna matrix. I'm using NCS v1.6.0-rc2 and example Direction fing connectionless...
Hello there,
I'm facing inconsistency across two nrf51 PCB boards in term of sending the device name. I'm running the same exact code on both. One is advertising the device...
As shown in the provided picture, the download worked after connecting, but the function does not work.
I have checked the following. 1. Check the operation status of...
Hi,
there are couple of examples on NCS with edge impulse. I would like to know how much space edge impulse add to the application, and to see if it can fit into nRF52840...
I have a customer that is using the nRF9160 embedded into their own device. Need to know if the nRF9160 is a module in which case the customer's end device will need to be...
I have written a string data from peer device, and i want to update the device name with the string in run time without resetting the SOC, how can I do it and what are the...
Hello
I am using HTTP to requests on the server with NB-IoT network on NRF9160 chip
I found that in the HTTP REQUEST command with 1 REV () function to get the results...
Hi Nordic,
I've implemented an extension of the NRF DFU protocol using the "external-app" type. The transfer is stored in external flash, and can be approx 1MB in size....
Hi
I have tested direction finding examples successfully., by default parameters. Theses projects are used as "TX" and "RX" in AoA mode:
https://developer.nordicsemi...
Hello, following this question - https://devzone.nordicsemi.com/f/nordic-q-a/76417/saadc-tasks_calibrateoffset-shall-only-be-used-before-tasks_start-or-after-events_end-nrf52833...
How i'm supposed to check if the device is transmiting any data? I used nRF52833 DK as a sink and node of wirepas mesh network, added another DK and configured it as a regular...
Hi,
I'm making an firmware for the nrf52840 that communicate throw usb to a computer.
First I used the uart library that works fine but required the Jtag and Jling which...
