Hello,
I have tried twice to request for SUPL license for getting A-GPS working but it has been denied both of the times. I think first time it got denied due to mismatch...
Hi Nordic Team,
The atomic fifo implementation is based on armv7-M, right now I want to port it into cortex-A processor, I made some changes to get it compiled without...
Hi,
Kit:nrf5340
Can you please tell me if there is any example in nrf connect SDK v1.5.0 related to data transfer concepts.
Is ble controller will be enabled during...
I'm was testing the gsp sample in samples/nrf9160/gps. It runs fine on my nRF9160DK and reports NMEA messages. However, when i ran it on my custom board, it failed in setup_modem...
Hi,
I'm attempting to obtain sensor values for a project to be completed less than a week from now and I have not yet started programming so any help would be greatly appreciated...
Hi
I am using nrf52832,SDK version: SDK : RF5_SDK_17.0.2 .
USE CASE:We have two central and one peripheral.We need to control two central with one peripheral(REMOTE...
Hi,
I'm using littlefs with an external flash. Everything works well, but if I look my parition manager I have a 24KB little storage automatically created
is it possible...
Hi,
I have developed a custom application on nRF54L15 and now I want to add OTA over BLE support in it.
For that, I am following Exercise 5 – FOTA over Bluetooth Low Energy...
I am trying to setup the dev. environment in OpenSuSE Linux, but, even though it says Linux, I only find support for Ubuntu.
I am blocked now setting connecting the board...
Hello,
I'm designing an application where I intend to authorize different users to access the functionalities of a device based on the nRF54 family.
The general idea is...
Hello, I'm using NFC Type 4 Tag (T4T) but I can't write to it. The tool I'm using is the nRF NFC Toolbox. From the app screen I generate a Record and then touch the tag to...
Good day, I'm trying to use pin 1.02 as a GPIO in a TF-M build using a (custom) non-secure board target, and I'm struggling to find the appropriate way to accomplish this...
When I first created the BLOB Transfer model, I had to analysis the DFU sample code because there was no BLOB Transfer model sample.
Is it possible for me to create a sample...
Hi, For supporting multiple different peripherals is it possible to get something back from a SoC observer which indicates the peripheral type? https://docs.nordicsemi.com...
We have a manufacturing project assembling the 0.35mm CSP package. We would like guidance on part handling, solder stencil specifications and any other process steps that...
I am developing a DFU (FOTA) feature via BLE on the nRF54L15 MCU using NCS v2.9.1 .
I am using MCUBoot direct-XIP with revert mode .
My application needs to detect the...
Hi Nordic Team,
I’m working with the nRF9160DK , specifically targeting the nRF52840 application core ( nrf9160dk_nrf52840 ).
While building a BLE Central application...
Hi Nordic team,
We’ve implemented a custom firmware update flow for our nRF5340-based device , which supports a robust single-image FOTA process using external NAND flash...
In our design, we wired the SD card in SPI mode on SPI bus 4 wich a maximum SPI frequency of 50 MHz or 25 MHz as these are supported by the SD card. We used FAT32 file system...
Due to board design flaws that led to insufficient rise time for 100kbps communication, I would like to configure my i2c node in the device tree with a baud rate of 10 kbps...
