Code_Replace_MainDotC.docx
Please look at the attachment of my code. Go to \nRF51_SDK_9.0.0_2e23562\examples\ble_peripheral\ble_app_template\pca10028\s130\arm5_no_packs...
I am in need of the usb-to-uart.hex firmware and the driver for it. This is required to test the radio dongle nRF24LU1+ device (32k) whether it can be programmed through USB...
I've been unsuccessfully trying to serialize BTLE example programs by SPI. I have two PCA10028 boards and I'm using SDK10. In addition to serialization examples, I've tried...
Hello,
Connection between linux router and NRf51 devices worked before I've updated kernel version from 4.09 to 4.3.
Now, with the same configuration and hardware, I'm not...
Hello,
Connection between linux router and NRf51 devices worked before I've updated kernel version from 4.09 to 4.3.
Now, with the same configuration and hardware, I'm not...
Hi
Does anyone know a CE—certified module based on the nRF24LU1+? Ideally, it should have an SMA connector, but any kind of antenna would be fine.
There are many modules...
Hi,
Your Dev Academy email-verification system may be broken, or I am broken :-)
After submitting the sign-up form, I am told to check my email to complete my registration...
Hi,
I tried the subsys/usb/console sample with nrf7002dk and I have ttyACM2. docs.nordicsemi.com/.../README.html
I copy the prj.conf to the end of the prj.conf of the...
Hello,
I am attempting to connect to a Wi-Fi network using Exercise 2 from Lesson 2 of the Wi-Fi training in Nordic Academy. However, when I try to connect to the network...
We are trying to configure our device, which is custom based on nrf7002dk for interface certificate testing. The requirements for testing are
Ensure correct Internet Header...
Hello,
Im trying to flash my dev board but im keep getting following error:
Error: One or more batch tasks failed: * 1057707318: [Probe] Emulator error: Failed executing...
Currently, in the early stage of code development with NCS 2.8.0, I'm getting some errors when configuring I2C (TWIM) for a sensor device in a custom board.
The overlay...
On the NRF7001 module there is a "Determine the trim value" section in the documentation. I have followed the "Receive-based approach" to determine the CALIB_XO value. This...
Hi,
I have several deployed devices that have been running for a while, using the nRF Cloud A-GNSS system with the nRF Location library. These devices were successfully...
hi I have recently been developing ncs on vs code. However, I encountered a strange problem. After I clicked build configuration, there was no output in the terminal, except...
Hello all,
I have this problem: when I add support for OTA my bonding information are canceled after power on. Without ota all is perfect.
Example: - Turn on the device;...
Hey there!
I am currently trying to upload a .hex file onto the board to flash it using the nRF connect programmer. But while flashing i get this error:
11:10:10.496...
Hello,
I am currently working on the Exercise 3 – Interfacing with ADC using nrfx drivers and TIMER/PPI sample. I have it operating, however I am wondering what is the proper...
Using NCS 2.6.2
set(PM_STATIC_YML_FILE ${CMAKE_CURRENT_SOURCE_DIR}/configuration/pm_static.yml) in the CMakeLists.txt works well to use static partitions for a appl+mcuboot...
