Hello. I am literally looking at the set_hrm_cccd function in Python used to write data. This is for the S130 heart rate collector example. I understand the sd.ble_gattc_write...
Totally new to Python but managed to get things like pyserial setup and I've been able run the ble sniffer. However that is as far as my Python knowledge extends, so I need...
pstorage_load and pstorage_clear appear to work fine, but whenever I do a pstorage_store the callback function is never called. This happens whether or not the Bluetooth unit...
Our USB keyboard using nrf24lu1p does not work on Mac OS 10.11.
Before Mac OS 10.11, USB keyboard was worked, but on Mac OS 10.11, it does not work.
I think your library...
In my design I need the RX to be standalone , I.E. no controller attached to it , does the programming STORE in the Chip ? If I set it up as a RX and set a specific Ch. Freq...
[Dev Env]
nRF51 DK
IoT SDK 0.8
IoT SoftDevice
[Question]
how i change my ip in ipv6_coap_server example use ipv6_address_set / ipv6_address_remove API.
To...
Hi Guys,
I have a MCU RTOS project. in Hardware board, builtin Nodic BLE chip over UART,RTOS BLE stack works fine.
We also have a MCU RTOS Emulator based on Qemu,we...
Hi,
I'm using the nRF52840 using SDK 17.0.2. I've implemented the CLI for flashlog as well as several other custom commands. It works well when entering commands on the...
Hello, I am studying the subject example project to understand how to create my own characteristics and adapt the project for our application.
What is the purpose of the...
how to compile openthread library files for nrf52833,
i followed the procedure as below
start with a fresh copy of the SDK, and make sure you place it as close to the...
Hi Everybody,
We found little or no literature about readback_protection on the nRF5340 SOC. Our issue is that for development and debugging it is not practical to use nrfjprog...
I have created an application using SoftDevice S112 using board pca10056e and installed it on the nRF52840 DK. I want this application to run on the nRF52805 so I want to...
Dear Nordic support,
We are trying to know the power consumption of nRF52840 SoC, by prediction and measurements.
The Online Power Profiler for Bluetooth LE tool estimates...
Hi,
I am developing a product based on a nRF52833-QDAA chip, we use the two uarts to transmit data to another MCU and AT commands to a LTE-M modem.
We use NCS 1.7.0 as...
The nRF connect program for desktop
https://www.nordicsemi.com/Products/Development-tools/nRF-Connect-for-desktop
Will it be updated to fully support Bluetooth 5? Extended...
Hi,
I got a problem with sending data via gazele protocols, i'm using example library gzll_ack_payload_ host and device, can somebody explain me how this code works?
i...
Hi.
I'm working on macOS Monterey 12.0 beta and trying to start nRF Connect for desktop (version 3.7.0). When i'm trying to start this application it's starting as blank...
Hi.
This question is to confirm again about below.
Is it possible that implement multiple advertising sets, some of them would be 1M and some would be CODED PHY. And...
