Hello：
Why Bluetooth Go to system-off mode, sd_power_ramon_set can not be stored. In D: \ RAM save nrf51_sdk_v5_2_0_39364 \ nrf51822 \ Board \ nrf6310 \ s110 \ ble_app_rscs...
Hi,
Recently I want to set up a dynamic network that with the node change this position ,the network will change dynamically.But there is the question,with the node's position...
Dir Sir. I am checking the current profile of nRF24AP2 in RX mode.
After "open channel" command, I found the peak current at 10ms interval until connection pass.
How does...
Hello,
I am using Nordic's UART service to communicate with my project. I use iOS and also Master Control Panel (with a dongle) on a laptop.
I have two questions:
...
SWI*_IRQ is using by softdevice to send event to application, I want to know which priority does softdevice set for them?
Does sd_nvic_critical_region_enter() disable...
I am a started guy.
I only need a bluetooth device (BLE) to check the signal and mac address.
What is the best choice?
I need the smallest and low powered!
Thank you...
Hi
Built and flashed ncs2.7.0 SLM application at NRF9151 DK. It will log booting log messages and then "Ready" as below.
Before ncs2.7.0, I found SLM application only...
Dear All.
Using, for instance, a peripheral nRF52840 SoC, would it be possible to change in real-time the text string being advertised, among several prerecorded ones, according...
Hi,
I am following the tutorial to implement the serial recovery on nrf52840DK https://academy.nordicsemi.com/courses/nrf-connect-sdk-intermediate/lessons/lesson-8-bootloaders...
Hello,
Im using SDK 15 ble pheripheral and central uart example on my custom nrf52832 board.
I would like to know how to set MIN_CONN_INTERVAL and MAX_CONN_INTERVAL for...
Hello,
I would like to send a reason code when disconnecting the client (nRF9160DK) and server in MQTT. How can I do this?
It seems that there is no argument to specify...
When I use nrf_dfu_mbr_copy_bl to do bootloader updating, the data is copied sucessfully, but I find some flash data are updated from 0xFE000 and 0xFF000：
The data is the...
I’m working on a BLE-based door sensor project and my focus is to optimize power consumption for maximum battery life. The code I’m using is designed for a beacon using sdk...
Hi,
really new to the Zephyr stuff and Nordic micros. I've been through the dev academy training examples and get how to use GPIO and I2C by getting a pointer to a device...
Hello,
I wanted to implement a bootloader on nRF52840 which is having 1024KB flash and 256Kb RAM. Can i get any link or tutorial on this if yes can anyone reply to this...
Hi all,
I've been trying to get the samples/sensor/lsm6dsl example working with the nrf52840-based Xiao BLE Sense and have had no luck.
I guess that it's due to the power...
Using NCS 2.5.1. nRF52832 being updated using external flash.
We're having an issue with DFU's on a product that is using a high percentage of the application space (~97...
Using nRF9160. Using NCS 2.6.0. Building for the nRF9160DK with nRF9160. We were wondering if there's a way to enable both the shell and serial bootloader on the same interface...
Dear All.
While trying to complete the DevAcademy course on nRF Connect Fundamentals, using the nRFCommand Line, the VSC, and the Extension Pack to configure the correct...
