Hi.
I am using S130 softdevice version.
Basically, I am using NUS Service and make a my own NUS central service as NUS_C.
It is correctly work at normal state.
When...
Hi All,
Please Reviwe for a attached circuit file(Chip ANT of nRF51822.pdf).
I also attach a datasheet of chip antenna applied for that circuit(SDBTPTR3015 Data Sheet...
to me it made sense that EN_AA settings are controlling the receiving pipes if an ACK has to be sent back upon receiving a valid packet.
then i thought that the settings...
I am using BLE_Gateway example defined in nRF51-ble-bcast-mesh to create an rbc_mesh over 2 nRF51422 devices . For now, I am just testing it out on 2 nRF51422; I will set...
Hello,
I see when you import an example from the pack installer ( for example pwm, ble, timer examples ) it arrives with the misc controls --c99 on by default , so I cannot...
Hi,
We're looking for a low-latency 2.4GHz solution (not BLE) and the nRF51822 is oft-quoted as providing low latency, but what are the typical ms figures we could achieve...
I noticed in the nRF extension in VS Code, there are the "pristine build" and "erase and flash to the board" options. I was curious when I should use these options instead...
Hi,
I am currently programming an nRF52 device with the NCS - I am confused about the API for the Zephyr controller, the API for the Bluetooth controller, and the Softdevice...
Hello,
I have the nrf9160 DK version nRF9160 SICA B0A. I have upgraded it to the latest modem firmware version 1.3.2.
I put my own SIM card and added in prj.conf the following...
Hi, I now aply ble_app_uart example for my custom board My board work perfect Some configurations in my code based on ble_app_uart Advertising_interval : 64ms Tx: 0 Some changes...
I am trying to get the example secure bootloader uart working on my nRF52832 development board but I am seeing a lot of TX errors on the RTT log output from the debug version...
Hello everyone,
I have built a product with the nRF52840 that is ready to be manufactured. Connect JTAG/SWD and upload image to each board seems grossly inefficient. Is...
Good day
I am currently developing a system using the nRF52833. A nRF peripheral device needs to be connected to both a mobile app and a nRF central device. The software...
I'm working on an Android app that scans and makes BLE connections. The app scans for devices advertising a particular service. The app uses startScan with a PendingIntent...
Hi,
I am new to this concept. I am trying to implement the nfc pairing connection in nordic nRF52840 but i don't no where to start and how to implement this one. Can anyone...
Hi,
How to configure the following two CONFIG to connect the nRF9160 module to the nRF Cloud
CONFIG_NRF_CLOUD_CLIENT_ID_SRC_COMPILE_TIME CONFIG_NRF_CLOUD_CLIENT_ID
...
MPU6050 cannot calculating the value of 3 axis and the value return is 0. What is problem? How can I fix it ? Thanks for helping me. AD0 open.Adress is 0x68
Here is my...
Hi,
We are evaluating Segger SystemView for analyzing our embedded applications. However, we encountered occasional overflows in SystemView. These overflows are caused by...
Hello
how can i found a input capture example to read external 125KHz PWM Signal, so we can measure the time from falling/falling edge or rising/rising edge or falling/rising...
